SiteMap
+
Manufacturer+
TAKASHIMA HIGH SPEED
WIRE STRAIGHTENING MACHINE
WORKS CO.,LTD.

TAKASHIMA HIGH SPEED STRAIGHTENING MACHINE

   
Ø0.1-Ø3.2   Ø2.5-Ø6.0    Ø4-Ø9   Ø6-Ø28
 
The picture expanded when the photograph was clicked can be seen.
    Capacity(mm)
Ø2.5-Ø6.0
TCH-6L-W

TCH-6L-W

FOR HIGH TENSILE STRENGTH WIRES(W)

Feed Speed(m/min)
30-60

with Variator

    timum for processing wires
high in tensile strength.
Since twisting is prevented
by causing the front and
rear straighteners to turn
clockwise and counter-
clockwise, sophisticated
products can be obtained.
       
       
    Capacity(mm)
Ø2.5-Ø6.0
TCH-6S-FC

TCH-6S-FC

FLYING CUT TYPE(FC)

Feed Speed(m/min)
30-60
with Variator

   

The flying cut completely
eliminates roll slip marks,
local swelling in the spinner
section, and twice cutting.
The round blade to round
blade cutting system causes
the cross section to be cut
almost at right angles, so that
it is ideal for processing wires
that require high precision,
such as wires supplied to
automatic milling machines.

       
     
Capacity(mm)
Ø2.5-Ø6.0
TCH-6S

TCH-6S

AIR CLUTCH TYPE(TCH)

Feed Speed(m/min)
30-60

OPTION
    NC servo positioning ruler
Never causes twice cutting.
       
       
    Capacity(mm)
Ø2.6-Ø6.0
TCH-6L-NS

Feed Speed(m/min)
7-15

with Variator

TCH-6L(NS)

SHORT LENGTH CUTTING TYPE

NS Cutting System
    The NS system is such that the
cross section of the wire cut by
it is not damaged, leaving the
cross section almost true circle
as it is cut at right angles.
Thanks to this advantage,
this machine is widely employed for
processing of micro shafts for
small motors, VTR sets, timer
printers, floppy disks, word
processors, etc., or needle rollers.
sprocket chain pins, etc.
Which require clean cut cross
sections. Thus, as a machine
providing an innovative cross
section, this machine is satisfying
many users.
       
      TG-4AL-W-NS

TG-4AL-W(NS)

FOR HIGH TENSILE STRENGTH WIRES(W)

Capacity(mm)
Ø2.5-Ø6.0

Feed Speed(m/min)
7-30

    Optimum for processing
wires high in tensile
strength.Since twisting is
prevented by causing the
front and rear straighteners
to turn clockwise and counter-
clockwise, sophisticated
products can be obtained.
       
       
    Capacity(mm) TG-4F
  Th. 0.3-35
Wd. 5.0-100

TG-4F

FOR SPECIAL SHAPED WIRES(F)

Feed Speed(m/min)
30
    Exclusive for flat, square and
special shaped wires,this
machine employs a leveler
straightening system that
consists of a vertical
straightening roller and
horizontal straightening roller,
capable of providing high precision.
       
       
TG-4AL

STANDARD TYPE

Capacity(mm)
Ø2.5-Ø6
TG-4AL
Feed Speed(m/min)
40
       
Ø0.1-Ø3.2   Ø2.5-Ø6.0    Ø4-Ø9   Ø6-Ø28
UP